Dust-Free Sanding Table | Woodsmith Tips - created via http://pinthemall.net

Dust-Free Sanding Table | Woodsmith Tips - created via http://pinthemall.net

Small Parts Clamp (Softer grip than pliers.) The jaws of the clamp are made from a short section of 1 1/4" dowel. The dowel is split down the center and then the two halves are reassembled with a bolt, a wing nut and a few washers that space the "jaws" apart. A wedge inserted at the back of the clamp forces the jaws together. Start by drilling the bolt hole through the dowel section and then tapering the jaw end with a sander. Cut the dowel and add the wedge.

Small Parts Clamp (Softer grip than pliers.) The jaws of the clamp are made from a short section of 1 1/4" dowel. The dowel is split down the center and then the two halves are reassembled with a bolt, a wing nut and a few washers that space the "jaws" apart. A wedge inserted at the back of the clamp forces the jaws together. Start by drilling the bolt hole through the dowel section and then tapering the jaw end with a sander. Cut the dowel and add the wedge.

Easy Mini Drill Press

Easy Mini Drill Press

I was looking for an easy mini drill press for drilling PCB for example.I didn't found exactly what i wanted in DIY projects or shop so i built this :)This press is strong, accurate and not expensive !

I recently had to cut a long groove into a stainless steel tube, and because I had to watch closely to see where I was cutting, I wanted to add some e...

Improvised Safety Guard for Rotary Tool

I recently had to cut a long groove into a stainless steel tube, and because I had to watch closely to see where I was cutting, I wanted to add some e...

Pinterest
Search