More ideas from

"I love the surface finish that this plastic has. It prints very well." -domenic l.

REFLECT-o-LAY is a new filament that, during daylight, has an ordinary grey finish, but, when hit with beams of light in the evening, becomes reflective. REFLEC

"Thought printing with PETG was going to be more difficult than it was. Adjusted the nozzle temp ..." -Timothy R.

It's finally here! The PrintDry filament dryer is designed to actively reduce the water content in a filament. Most 3D printing filaments (ABS, PLA, PETT, PC and Nylon) are hygroscopic materials, which have a strong affinity for moisture. Eliminate moisture from your filaments PrintDry now available in Canada Exclusivly through

"Castle print, about 80 hours job @ 100 microns layers" -Daniel L.

"T-800 print, 200 microns layer height, great job !" -Daniel L.

"It is a difficult material to print at first. However, after some practice, you…

"Beautiful filament to work with. Never had a failed print with it. Great…

"I have had a lot of frustration getting good prints. It's a long story but a…