More to explore:

Tips

There’s more to see...
Come take a look at what else is here!
Visit site
  • Elizabeth Delacare

    This site has a TON of painting tips! Must go to this site before painting anything. | I've done the hair dryer trick on painters' tape before. Works really well!

  • Wowie Downey

    Good painting tips. I love the hairdryer to remove sticking masking tape, the coat hanger across the top of the can and the pimple pads for cleaning up latex drips!

  • KC Fischer

    This site has a TON of painting tips! Must go to this site before painting anything. Hopefully I'll get to some painting projects soon.

  • Mimi Maui

    This site has a TON of painting tips! Must go to this site before painting anything. Pictured: If masking tape tears as you remove it or pulls off flakes of finish, heat it with a hair dryer. Heat softens the adhesive. Then pull the tape off at a 90-degree angle.

Related Pins

Yep, this could have helped me when we were painting this past summer! This site has other great painting advice as well!

The easiest way to hang a picture! Why didn't I think of this? Pin now, read later! #tips

Mess-Free Painting Tips Follow these tips to make your painting project easier and cut your clean up time in half.

Finishing spindles is a pain because you have to finish three sides, let them dry and then turn them over and do the unfinished side. But not if you drive long drywall screws into the spindle ends and then rest the screws on two boards or sawhorses. An added bonus is that you can keep your fingers out of the wet finish by holding onto the screws as you paint and turn.

This site has a TON of painting tips! Must go to this site before painting anything.

10 Paint Secrets: what you never knew about paint. Good to know! Check this out!

Use an old cardboard box to make a 'spray booth' to prevent paint overspray when painting inside with spray paint

Cut out the side of a milk jug to create a paint holder with a built-in handle and brush-holder. | 47 Tips And Tricks To Ensure A Perfect Paint Job

Paint all four sides of spindles at once. Finishing spindles is a pain because you have to finish three sides, let them dry and then turn them over and do the unfinished side. But not if you drive long drywall screws into the spindle ends and then rest the screws on two boards or sawhorses. An added bonus is that you can keep your fingers out of the wet finish by holding onto the screws as you paint and turn.