Things you need for this DIY: ✝ a small box (a tissue box works really well) ✝ a craft knife ✝ a ruler ✝ thread ✝ a beading needle or beading wire ✝ seed beads Total time: 15 mins for the loom 45 mins-1.5 hours for the bracelet I feel like I'm at camp again. First remove the plastic. Then, using the hole as your guide, remove the top of the box along the longer sides, leaving behind the top along the shorter sides. Snip the sides of the remaining box top. Fold down. Using a ruler, cut slits along the edge, every 1/16 of an inch. Repeat on the other side. You have your loom! It's not the prettiest thing I've ever made, but it works really well. Onto bracelet making: Get out your beading needle (a very thin needle) or make one using a piece of beading wire (very thin wire) folded in half and twisted at the end. Take a long piece of thread (2-3 feet depending on how long/wide you want your bracelet) and tie a bead close to one end. This will be your stop bead, it will hold your thread in place. Put the same number of beads on your thread as there are spaces on your loom. Holding the beads underneath the loom threads, pop each bead into a space and hold them there. Then, go back through the beads OVER the threads. Be careful not to go through your stop bead. Pull it taut and repeat... ...like a lot of times. Remove your stop bead and tie off the ends. Done! These bracelets take about the same amount of time as woven friendship bracelets but have the added advantage of not needing a pattern.