There’s more to see...
Sign up to discover and save different things to try in 2015.
Visit Site
  • Stephanie Massey

    Build a mini water garden oasis! LOVE this! Can't wait to do it...also add to EK fairy garden ideas....

  • Jane Sell

    Love the water fountain and mini water garden oasis.

  • Sandi White Thomas

    potted ponds: mini water garden oasis...

  • Jenna Willingham

    Bucket Fountain The soothing sound of water is a lovely accessory in any garden. Even if you don’t have room for a majestic pond, you can create your own small-scale oasis in a container. The tiniest trickle will reduce ambient noise and significantly increase your enjoyment of an urban patio, balcony or rooftop garden. The plants Advertisement Corkscrew rush (Juncus effusus ‘Spiralis’): A marginal water plant, meaning it can be grown either at the edge of or in a pond but still in soil, this unusually shaped rush reaches 60 centimetres tall and does best in sun or part shade. Make sure you’re not buying J. balticus ‘Spiralis’, which is less upright and has a tendency to spread. Zone 4 Dwarf or miniature cattail (Typha minima): Another marginal plant, it reaches up to 45 centimetres tall and grows best in sun or part shade. Zone 3 Chameleon plant (Houttuynia cordata ‘Chameleon’): A marginal plant that produces white flowers in early summer, it must be planted in a perennial bed and mulched to successfully overwinter. It reaches 15 centimetres tall, does well in sun or part shade and tends to spread. Zone 5 Needle rush hair grass or spike rush (Eleocharis acicularis): A marginal as well as an oxygenating plant (essential for the survival of fish), this North American native grows to about 30 centimetres tall and does best in sun or part shade. Zone 3 Fairy moss (Azolla caroliniana and A. filiculoides): This tiny moss (one to three centimetres across) floats on the surface of the water. The green fronds turn red in fall; the plant spreads rapidly. Overwinter indoors; native to North America. Tub time (shown above) A large, galvanized-steel tub (30 centi-metres deep, 46 centimetres square) serves as the base for this water feature. The pump was installed on the bottom, then covered with a plastic pot. A trick I learned from Canadian Gardening’s previous editor, Beckie Fox, is to use a piece of gridded plastic (the type that’s installed over fluorescent lighting) as a foundation for the top layer of stones. I added a variety of larger sizes (not pebbles) and finished it off with a flat slab of slate, which forms the ledge over which the stream of water runs. Pump primer To make these potted ponds, I used a 95 GPH pump (GPH stands for gallons per hour). Although 95 GPH may sound like a lot, it’s one of the smallest sizes on the market and is only appropriate for containers. Here’s the formula for calculating the volume of your pond or container using imperial measurements: length x width x depth (all in feet) will give you the cubic feet of a rectangular container. Multiply this by 7.5 to obtain the number of U.S. gallons. The galvanized-steel tub used in Tub time measures one foot deep by 11⁄2 feet square: 1 x 1.5 x 1.5 x 7.5 = 16.88 U.S. gallons. To calculate the size of the pump needed, divide the total number of gallons by two, which means you would only need an 8 GPH pump for a container this size. But that’s just the beginning. The size of the container can also influence the strength of pump required. The longer the tubing from the pump to the water output, the more GPH is needed to keep the water moving. A waterfall entails its own set of calculations, as distance from water pump to water output can be significant. For the best advice and information on selecting a water pump, visit a retailer that specializes in water gardens. Installing water plants To install water plants, remove them from the plastic containers they're sold in, wrap the soil and roots in burlap, then place in small mesh baskets (specifically made for water plants and available at most garden centres). Cover the top with pea gravel (this will keep the soil down). Remember to check the pump's filter periodically, as this is where residual soil will collect. The smaller the pump, the smaller the filter and the more frequently it needs to be cleaned out.

Related Pins

Raised beds, collecting rainwater as well. - perhaps tiered beds can have a French drain at the end that catches excess water run off from the rain. It would be a larger area to collect rain water and would only be extra If the other plants were all watered.

The Brochstein Pavilion at Rice University

Water trough feature. Great idea for watering the horses after a ride.

Hometalk :: DIY Water Features Inspiration :: Jamie's clipboard on Hometalk

Cool idea for a water garden instead of putting in a pond. Can even have fish!

  • Violet Upton

    Uh? She put fish in this pond then added Mosquito dunks? The fish eat the mosquito. Then she bought fish food?

The Exotic Garden Blog | The Exotic Garden by Will Giles in Norfolk - Subtropical Plants in a temperate climate This garden was designed by Claudia de Yong for the Hampton Court Flower Show in 2004, called 'Court Garden' it won an RHS Silver-Gilt medal in 2004. www.claudiadeyong...

'the EDGE effect' teaches that we always find abundant thriving universe of life around edges in permaculture. splashduck. #Jardin #Aurey

Zen water feature -- Curated by: Blue Valley Aquatic Landscapes | 300 sigalet road Lumby BC v0e 2g6 | 250-547-2525

How to Create a Pond Using a Pot... Easy DIY with Aquatic Plants and Water...That's all it takes to create a successful water garden in a container.

DIY::Easy mini water feature in an old bathtub. LOVE this!...

A Water Feature for a Shade Garden